Garage Door Opener Repair Valley

Omaha Garage Door Repair was contacted by a homeowner in Valley, NE, who was having issues with their garage door opener. They said the remote was not working, even after changing the batteries, and neither was the wall switch. We asked about any flashing lights on the opener, and the homeowner confirmed that some lights were flashing. We then inquired about their opener's exact brand and model because we suspected that the issue might be with the logic board. When we arrived at the site, our suspicions were confirmed—the opener's circuit board had been damaged by moisture. After replacing the opener's logic board, we checked everything and conducted test runs with satisfactory results. Thanks to our expert garage door opener repair, our client did not have to buy a new one. High-quality service is all in a day's work for our technicians!

Your garage door opener's circuit board is its brain. It allows the opener to receive signals from your remote and start the opening or closing process. With a functioning circuit board, your garage door opener is useful. Unfortunately, the circuit board can malfunction like any other garage door component. Several reasons can stop your opener from functioning properly, including failing circuit boards. When this happens, call us at Omaha Garage Door Repair to repair or replace your unit's circuit board and restore functionality to your door.

There are a few signs that your garage door opener's circuit board may be faulty and cause erratic behavior. Pay attention to these indicators and have the board replaced as soon as possible to avoid further issues.

What Indications Might Point to a Broken Garage Door Opener?

One of the crucial components of your garage door system is the door opener. Without it, you and your family would risk serious injury. Furthermore, using an opener with faulty components can damage other parts of your system and shorten its lifespan.

Common Signs of Opener Malfunctions

• Your opener's motor can become loose or damaged over time from vibrations or resonance while running. To prevent your opener from falling from the angle iron, you should repair it as soon as possible to stop further damage.
• When your garage door starts to reverse while you open it, it is most likely because of damaged safety sensors. It is especially common in older models of garage doors.
• Corrosion can cause serious damage to your garage door opener by damaging the limit switches inside. Over time, moisture and oxidation can build up and cause these switches to corrode, eventually leading to a breakdown of the opener motor.

Signs of a Failing Garage Door Opener Circuit Board

Problems with your opener's logic board can be difficult to diagnose and often result in strange, unpredictable issues. To avoid these potential problems, it is always best to have your opener's logic board inspected by certified garage door technicians.

The following are the primary indicators of a damaged circuit board in a garage door opener:

• The warning light either flashes or glows steadily.

• Even if plugged in, your sensor eyes do not receive electricity. Determine if they are working by placing something in front of them and watching to see if they sense it.

• Your remote control or keypad is not functioning as it should. If changing its batteries does not solve the issue, consider looking at the logic board.

• The LEDs on your photo-eye sensors are not flickering, or there is no light.

Garage Door Repair Near Me

Owning a home comes with much responsibility. In addition to keeping up with maintenance, you also need to be aware of security issues. Having a functional and reliable garage door is one of the most crucial parts of keeping your home safe.

Omaha Garage Door Repair is the place to go for top-notch garage door repair, maintenance, and installation services. In addition, our same-day emergency repair is available no matter where you are in Omaha or Lincoln, Nebraska. So call us today to get started!